Rode
The line a small boat rides to when anchored, also called the anchor line.
How it works
On small boats the rode is usually a length of line, most commonly nylon, with a short length of chain between the line and the anchor. Large vessels may use an all-chain rode. The chain lowers the angle of pull on the anchor, keeps the line off a rocky or coral bottom, and does not hold sand or mud the way rope does.
Each link in the system must be tied to the next strongly. The Boat Crew Seamanship Manual describes an eye splice with a thimble and swivel at the end of fiber line, then shackles to the chain and from the chain to the anchor shank. Chafing gear goes on the rode where it passes through the chock and over the side.
How much rode you pay out is the scope. The manual gives a ratio of 5 to 1 up to 7 to 1 for normal conditions and 10 to 1 for heavy weather, measured from the bow chock to the bottom, and it wants the lower end of the rode at an angle of 8 degrees or less with the bottom. Markers every few feet or fathoms on the line let you read off how much is out.
What to know for the exam
- Questions ask how much rode to pay out so the anchor digs in, the scope ratio for normal and heavy weather, and the angle the rode should make with the bottom.
- There is also a calculation type: given depth plus the bow chock height, find the length of rode for a stated scope.
- The topic sits in the anchoring and mooring parts of the Deck General and OUPV modules.
Length of rode for a given scope
A boat anchors in 18 feet of water with the bow chock 4 feet above the surface, so the vertical distance is 22 feet. A 7 to 1 scope needs 22 x 7 = 154 feet of rode. For heavy weather at 10 to 1 you would pay out 220 feet.
Common questions
Sources
- USCG Boat Crew Seamanship Manual, Appendix A (Glossary)
- USCG Boat Crew Seamanship Manual, Chapter 10, Section H (Anchoring), H.2, H.7, H.13 and H.17
More Seamanship and Deck terms
Parts of a vessel, deck fittings, lines, knots and anchoring and mooring words.