Skip to content
Mariner IQ
Start Free
Seamanship and Deck

Anchor

A shaped iron device that grips the bottom and holds a vessel in her berth by the chain or rope attached to it.

How it works

An anchor holds by its flukes digging into the bottom. The Danforth type most small boats carry has a shank that takes the rode, flukes that bury, a crown that lifts the back of the flukes, and a stock that stops it rolling. The complete system is the anchor, the rode and the fittings that join them. The Navy text adds that with a stockless anchor you need a long scope so the shank stays on the bottom; with too short a scope the flukes may roll out.

How much rode to put out is a judgment about depth, vessel and weather. The Boat Crew Seamanship Manual defines scope as the ratio of rode length to the vertical distance from the bow chocks to the bottom, so depth plus the height of the chocks above the water, and gives a ratio of 5:1 to 7:1, or 10:1 in heavy weather. Bowditch's representative procedure veers chain to five to seven times the depth of water, the exact figure depending on vessel type and expected weather, with the maximum height of tide taken into account.

Once the anchor is set, the navigator draws two circles on the chart around the position where it was dropped: a swing circle to check for hazards and a drag circle to confirm the anchor is holding.

The swing circle radius is the ship's length plus the scope of chain released, and it is checked against the lowest expected tide for shoals. The drag circle radius is the hawsepipe-to-pelorus distance plus the scope, and a fix outside it means the anchor is not holding.

What to know for the exam

  • Deck questions ask how much chain or rode to veer, how to work out a scope from depth plus the height of the bow chocks, what the swing and drag circles are for, and which tide height to use for each check.
  • Seamanship questions cover choosing an anchorage: the type of bottom, staying clear of other vessels and traffic lanes, and avoiding a spot much deeper than needed over the tidal range.
  • Lights questions cover how an anchored vessel is marked, which is covered under all-round light.
WORKED EXAMPLE

Rode and swing circle

A boat anchors in 18 feet of water with its bow chocks 4 feet above the water, so the vertical distance to the bottom is 22 feet. At 7:1 the rode is 7 x 22 = 154 feet, and in heavy weather at 10:1 it is 220 feet. For a 120-foot ship that veers 210 feet of chain, the Bowditch swing circle radius is 120 + 210 = 330 feet, checked for shoals against the lowest tide expected.

Common questions

Sources

  • Army FM 55-501, Marine Crewman's Handbook, GlossaryMarine Crewman's Handbook, FM 55-501
  • Bowditch, The American Practical Navigator, Vol. 1, Chapter 11, representative anchoring procedure (swing and drag circles)Bowditch, Pub. 9 (NGA)
  • USCG Boat Crew Seamanship Manual, Chapter 10, Sec. H (Ground Tackle)
  • NAVEDTRA 14067, Seaman, Chapter 4, Ships' Anchors

More Seamanship and Deck terms

Parts of a vessel, deck fittings, lines, knots and anchoring and mooring words.