Bollard
A single strong vertical fitting, usually iron, on a deck, pier or wharf, to which mooring lines or a hawser may be fastened.
How it works
A bollard is a single strong upright, usually iron, found on a pier, wharf or deck. A ship's mooring line is placed on it by an eye or a bight. The Navy seaman text describes it as a strong cylindrical upright on a pier, over which the eye of a mooring line is placed. A pair of posts on the vessel itself are bitts, and the Cutter Seamanship Manual describes lines passing through chocks to bollards on the pier.
Putting two lines on one bollard has a procedure. If two eye splices or bights go on the same bollard, FM 55-501 says the second must be led up through the eye of the first and then dropped over the bollard. That is called dipping the eye, and it lets either line be cast off without disturbing the other.
The same handbook says what a bollard can suffer. When securing at high water, enough slack must be left in the lines so that at low tide they will not part, carry away bollards or in extreme cases list a vessel or capsize a small one. A different figure, bollard pull, is a towing limit. The Boat Crew Seamanship Manual defines it as the point where the static pulling force becomes such that any increase in engine load could damage the engine or the towing bitt, and the Cutter Seamanship Manual says never to exceed the cutter's rated bollard pull.
What to know for the exam
- A direct question asks what a bollard is, so the difference from a bitt, cleat and chock needs to be clear.
- Mooring questions ask how two eye splices go over the same bollard so that either can be cast off independently, and what to do about line slack when securing at high water.
- These items draw on the docking and undocking chapter of the Army Marine Crewman's Handbook.
Common questions
Sources
- USCG Boat Crew Seamanship Manual, Appendix A (Glossary)
- Army FM 55-501, Marine Crewman's Handbook, Chapter 4, Docking and UndockingMarine Crewman's Handbook, FM 55-501
- NAVEDTRA 14067, Seaman, Chapter 4, Bollards
- USCG Cutter Seamanship Manual, Chapter 4, Sec. C.2; Chapter 6, Sec. JCutter Seamanship Manual (USCG)
- USCG Boat Crew Seamanship Manual, Chapter 7, Sec. A.9.a.4 (bollard pull)
More Seamanship and Deck terms
Parts of a vessel, deck fittings, lines, knots and anchoring and mooring words.