Fuse
The simplest circuit protection device. Its element is smaller than the conductor it protects, so it melts before the conductor is harmed, and the fuse must be replaced once it opens.
How it works
A fuse protects a circuit by being the weak spot on purpose. Its element melts when current stays too high, which opens the circuit before the wire is damaged. The Navy NEETS text notes that the name comes from the Latin word for to melt and that a fuse is destroyed in the process, so unlike a circuit breaker it must be replaced once it opens.
Fuses are rated by current, voltage and time-delay characteristics, and you need all three to select a replacement. There are basically two physical types, plug-type and cartridge fuses, and both use a wire or a ribbon as the element. Some can be checked by eye, but others need a meter.
The meter test uses a basic fact about series circuits. A good fuse drops almost no voltage, so a voltmeter across it reads zero while the circuit runs. If the element is open, the full source voltage appears across the fuse, because no current flows through the rest of the circuit.
The NEETS safety points for replacement are to be sure the power is off and the circuit is discharged, to use an identical replacement if possible, to remove corrosion from the fuseholder and to make sure the fuse fits the holder properly. The same chapter also lists the conditions to check when doing preventive maintenance on fuses.
What to know for the exam
- The QMED electrician module asks how to check a fuse with a voltmeter, what a reading across an open fuse in a series circuit means, and how to select a fuse for a circuit with a stated normal current.
- Fuse questions compare fuses with circuit breakers: one is replaced after it opens and the other is reset, and each has its own time-delay ratings.
- Expect them to cite the Navy training manual by name, so use its statements, such as the three ratings and the replacement precautions.
Current drawn by a heater
A 1,200 watt heater on a 120 volt circuit draws 1,200 / 120 = 10 amperes. Any fuse in that circuit must carry that 10 amperes without opening, so its current rating has to be above the normal load, while staying within what the wire can carry. Use the manual or equipment rating table for the actual rule.
Common questions
Sources
- NEETS Module 3, Circuit Protection, Control and Measurement, Chapter 2, Circuit Protection DevicesNEETS Module 3
- NEETS Module 3, Circuit Protection, Control and Measurement, Ch. 2 (Fuse ratings, fuse types, replacing fuses)NEETS Module 3
More Engineering terms
Pumps, pressure, boilers, electrical basics and propulsion terms for engine department exams.