Skip to content
Mariner IQ
Start Free
Engineering

Electric current

Also called ampere, direct current

The flow of electrons past a reference point, measured in amperes. Direct current flows in one direction only.

How it works

Current is what a voltage makes happen in a closed circuit. The Navy NEETS text measures it in amperes, where one ampere means one coulomb of charge passes a point each second, and one coulomb is the charge of about 6.28 x 10^18 electrons. Electron flow rises and falls directly with the applied voltage, so more voltage in the same circuit means more current.

Resistance sets how much current a given voltage drives. Ohm's law says current is directly proportional to voltage and inversely proportional to resistance, so doubling the resistance halves the current. That is the same relationship you use to work out a heater element, a lamp or a motor winding on the electrician and engineering exams.

Direct current flows one way only, the way a battery drives it. Alternating current reverses, which is why the generators, transformers and motor controllers on an exam list treat it separately. For small currents the text uses the milliampere, a thousandth of an ampere.

What to know for the exam

  • The QMED electrician module applies current constantly: you are given volts, ohms or amperes and asked for the other quantity or for power, using Ohm's law and the power formulas from NEETS Module 1.
  • Power questions combine current and resistance, such as a heater element of a stated resistance carrying a stated current, and ask how many watts it dissipates.
  • Circuit protection questions tie current to fuses and breakers, which open when current goes above their rating, and to meters, since an ammeter reads current while a voltmeter reads the voltage across a device.
WORKED EXAMPLE

Current in a resistive load

A 24 volt supply is connected across a 6 ohm resistor. Ohm's law gives I = E / R = 24 / 6 = 4 amperes. The power dissipated is E x I = 24 x 4 = 96 watts, which is the same as I squared times R: 16 x 6 = 96.

Common questions

Sources

  • NEETS Module 1, Matter, Energy and Direct Current, Appendix I (Glossary)NEETS Module 1
  • NEETS Module 1, Matter, Energy and Direct Current, Ch. 3 (Ohm's law and power)NEETS Module 1

More Engineering terms

Pumps, pressure, boilers, electrical basics and propulsion terms for engine department exams.