General Engineering
Gate Valve Cutaway With 14 Numbered Parts, Body to Handwheel
Exam reference: GS-0047 (the label exam questions use for this figure)
What the figure shows
A flanged gate valve is cut open so you can see inside, with blue arrows numbered 1 to 14. Numbering starts at the body at the bottom (1) and climbs through the seat ring, wedge or disc, stem, gasket, bonnet, packing and the gland studs and nuts. The handwheel (12), washer (13) and nut (14) sit at the top.
How to read it
- Start at part 1, the body at the bottom, and follow the numbers upward to the handwheel, washer and nut at 12 to 14.
- Look at how the stem meets the wedge or disc to judge whether the stem travels up or only turns in place.
What exam questions ask
- Which statement about the valve is true. The key calls it a non-rising stem design: the stem is threaded into the gate and turns in place while the gate travels along it, so stem height does not show valve position.
Common mistakes
- Do not assume one turn opens it: handwheel gate valves normally need many turns from closed to full open.
- Gate valves are intended for full open or full closed service, not for throttling flow, and their seats are generally renewable or repairable.
Related figures
General EngineeringHose Fitting Detail With Dimension Table
General EngineeringPiping Schematic With Numbered Valve Symbols
General EngineeringVertical Lube Oil Pump Dimensions and Data
General EngineeringThird Angle Projection: Right Side View
General EngineeringLimit Sensor Assembly Drawing and Ports
General EngineeringOily Water Separator Parts, Numbered 1 to 25