Skip to content
Mariner IQ
Start Free
Stability and Construction

Ballast

Weight placed in a vessel to maintain its stability.

How it works

Ballast is weight that a ship carries on purpose, and its jobs are practical. The Navy's NSTM chapter on weights and stability lists them: to improve transverse stability, to adjust trim, to provide adequate immersion, and to eliminate an inherent list. Ballast can be solid, such as lead or iron, or water in tanks that can be filled and pumped out.

Water ballast changes the ship's condition while she is operating. Taking it into a low tank lowers the center of gravity, and the Boat Crew Seamanship Manual says that generally the lower the center of gravity, the more stable the vessel. Pumping it out of the end that is aground lightens that end, and FM 55-501 says to pump bow to stern if the bow is aground and stern to bow if the stern is. It also warns against emptying the tanks completely, since some fuel and water must stay to run machinery.

Ballast has its own hazards. A tank that is only partly full has free surface, and the Boat Crew Seamanship Manual says to minimise the number of partly filled tanks and to ballast with seawater as necessary. In small passenger vessels, 46 CFR 178.510 says solid fixed ballast must be stowed so it cannot shift and cannot be removed or relocated without approval from the OCMI.

What to know for the exam

  • Stability questions in the Deck General modules ask what ballast is for, and how added or removed weight changes trim, list and the center of gravity.
  • Engineering safety and environmental modules ask about the rules on ballast in fuel oil tanks, which 33 CFR 155.440 bars in new oceangoing ships of 4,000 gross tons and above other than oil tankers, and about discharging ballast that exceeds 15 ppm of oil.
  • Damage control questions cover correcting a severe list or trim caused by off-center ballast with counterflooding, and regulation questions cover solid fixed ballast on Subchapter T vessels and the free surface that slack tanks create.

Common questions

Sources

  • USCG Boat Crew Seamanship Manual, Appendix A (Glossary)
  • NSTM Chapter 096, Weights and Stability, Para 096-1.3.1 (purpose of ballast)NSTM Chapter 096
  • Army FM 55-501, Marine Crewman's Handbook, Chapter 4, Handling Grounded Harbor Craft (removing ballast)Marine Crewman's Handbook, FM 55-501
  • USCG Boat Crew Seamanship Manual, Chapter 9, Sec. B.2 (free surface effect)
  • 46 CFR Part 178, 178.510 (ballast)46 CFR 178.510 on eCFR

More Stability and Construction terms

Stability, load line, watertight integrity and hull structure terms.