Gas Turbines
LM2500 Gas Turbine: Bleed, Cooling and Sump Vent Air Flows
Exam reference: GT-0017 (the label exam questions use for this figure)
What the figure shows
A color cutaway of a gas turbine engine with black piping and labeled arrows for each air and vent flow. Labels include ambient air, 8th, 9th, 13th and 16th stage bleeds, 9th and 13th stage cooling, sump pressurization, frame vents, thrust balance, high pressure recoup, the air-oil separator, sump vent and separator discharge.
How to read it
- Pick the bleed stage named in the question and follow its line from the compressor to where it ends.
- Separate cooling flows from sump pressurization and vent flows; the vent lines lead to the air-oil separator.
- Remember earlier stages give cooler, lower pressure air; later stages feed the hot section.
What exam questions ask
- What each bleed stage serves. Eighth stage air pressurizes and cools the lube oil sump seals; ninth stage air cools the power turbine; thirteenth stage air cools the second-stage high-pressure turbine nozzle.
- What starts a fire emergency stop. The module fire shutdown switch, activation of either module CO2 system, or a UV flame detector each initiates it.
- What to do if lube oil scavenge temperature stays above 300 degrees F after reducing power. Shut the engine down and troubleshoot.
- When the igniters switch off. They de-energize once the gas generator passes a preset speed during the start, since combustion is then self-sustaining.
- How routine compressor water washing is done. The engine is turned by the starter motor, not fired at any power level.
Common mistakes
- Mixing up the stages: the second-stage nozzle uses thirteenth stage air, while power turbine cooling and balance piston pressurization use ninth stage air.
- Tying the igniter cutout to power turbine speed. It is keyed to gas generator speed.
- Choosing a single fire stop trigger. Each listed event initiates it, so no one of them is the only cause.
Related figures
Gas TurbinesGas Turbine Fuel Oil and Module Console
Gas TurbinesSelf-Synchronizing Clutch Cutaway
Gas TurbinesGas Turbine Borescope and Probe Port Map
Gas TurbinesLM2500 Internal Air System Cross Section
Gas TurbinesGas Turbine Fuel Pump and Control Flow
Gas TurbinesGas Turbine Lube, Scavenge and Vent Lines