Electrical
Two Sectional Views of Lubricated Electric Motor Bearing Assemblies
Exam reference: EL-0218 (the label exam questions use for this figure)
What the figure shows
Two hatched cutaway drawings, A and B, show a machine end bell and the shaft bearing housing. Seven numbered callouts point to parts: 1 to 4 in view A and 5 to 7 in view B. The parts marked include fittings, a cross pin, a ball, a drain screw and bearing parts.
How to read it
- Read view A for callouts 1 to 4 and view B for callouts 5 to 7.
- Locate the grease fitting and the drain screw, since regreasing feeds new grease in at one and lets old grease out at the other.
What exam questions ask
- Which practice to avoid when regreasing the motor bearing in view B. Completely filling the bearing cavity, since overfilling causes churning, overheating and grease forced into the windings; fill it only partly.
Common mistakes
- Partial filling, and flushing old grease with an approved solvent or with the motor running unloaded, are accepted practices, not the ones to avoid.
Related figures
ElectricalSafety Switches: Double Throw Disconnect Views
ElectricalFour 12-Volt Batteries in Series-Parallel
ElectricalRegulated DC Power Supply and Waveforms
ElectricalFour 6-Volt Batteries in a Parallel Bank
Diesel & Motor PlantsTurbocharged 12-Cylinder Diesel Air Flow
Diesel & Motor PlantsPneumatic Airflex Clutch: Two Operating Views